The MkV comes with an 80 way cable and the first device connector is 32cm from the board connector. Thanks for the info and advice my friend. Last but not least ( ), be sure the FastATA drivers are in the first lines of the Startup-Sequence (before SetPatch command). The four channels and devices are recognized at boot time with the correct parameters and IDEFix maybe interferes with the MK-V.Īlso, you don't need to "skip" the vice in the SetPatch SKIPROMUPDATES "vice" QUIET line One good idea is to use an IDE Terminator for the mobo.ĭon't use IDEFix97 you don't need it with this board. I'm using SFS 1.279 with the same parameters: On primary channel connect only HDD's and use the secondary channel for DVD's.ĭon't use cable select, set the HDD-DVD jumpers correctly for master/slave. The vice of the FastATA MKV resides inside the board and must be v60.x With 40pin cables you can "go" to 45 or 50cms. With longer -more than 45cms- 80 pin cables you get r/w errors try using 35cms ones. I have two FastATA 4000 MKV working with IDE HDD's (320GB) & DVD's at PIO4 on my A4K's like a charm. Real HDD waits for 35 seconds, then displays Yellow Recoverable Alert, system resets, displays the same message then the screen goes black, with no more resets.Ģ. CF card waits for 35 seconds, then displays Yellow Recoverable Alert,Įrror: 0100 000F Task: 07003278.
BB ROM updates maybe?įastATA inserted, devices connected to FastATA Primary Portġ.
Real HDD almost starts to load WB but displays "Software Failure Program Failed (error #80000004). FastATA NOT inserted, devices connected to onboard IDE.įastATA inserted, devices connected to onboard IDE.Ģ.
0 kommentar(er)
